Ideal PH for Saltwater?
- Thread starter JoelWitt
- Start date
- May 3, 2014
- 59,670
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
The ideal pH is based on a lot of different things.
Here are some recommendations:
Pool School - Water Balance for SWGs
Here are some recommendations:
Pool School - Water Balance for SWGs
Yes, I've read that before. I've also seen that with a heater it is recommended to keep the PH a little higher 7.5-7.6. Just looking for confirmation if that is correct.
- May 3, 2014
- 59,670
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
I have the same heater and have to run my pH lower to manage CSI. No issues so far. I think manufacturers are so used to people not controlling their water chemistry that they are conservative.
Take care.
Take care.
PH of 7.2 to 7.8 is fine for heaters. Most SWG pools tend to have rising pH. TA at 50-60 and pH at 7.8 is very common for SWG pools.
Similar threads
