Correct. When cycle is over the alarm doesn’t appear anymore.
I can get a new flowSwitch yes.
I can get a new flowSwitch yes.
IC40 Reports Communication Lost
- Thread starter Ibolivarc
- Start date
Flying Tivo
TFP Guide
- Jan 24, 2017
- 2,962
- Pool Size
- 7500
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
This is normal operating parameters. Then you just have a thermistor problem. Post some test results please.
I will purchase the thermistor and post results. One question, is the thermistor responsible of giving me a bad PPM reading?
Flying Tivo
TFP Guide
- Jan 24, 2017
- 2,962
- Pool Size
- 7500
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Yes but you should never relay on the SWG ppm readings. Use your K-1766 for salt titration.
Hi
Using an electronic TDS to measure salt. It measures 2700 ppm and system is jumping between 250 to 3050. Meaning it’s not reading the salt properly and thus not produce chlorine.
waiting feo the thermistor to arrive. Still think is the thermistor. This morning reading were perfect. And whencycle started today (9 pm) the salt design is 250 va 3050 in the morning. Doesn’t make sense
Using an electronic TDS to measure salt. It measures 2700 ppm and system is jumping between 250 to 3050. Meaning it’s not reading the salt properly and thus not produce chlorine.
waiting feo the thermistor to arrive. Still think is the thermistor. This morning reading were perfect. And whencycle started today (9 pm) the salt design is 250 va 3050 in the morning. Doesn’t make sense
Similar threads
