Iaqualink Install-Solar Sensor not working

[Coolpool2008]

Hi Guys:

I just switched over to the Iaqualink from my older PDA setup. I switch the board out and replaced all the wires in the same places. However, my solar sensor does not appear to be working. The Solar turns on when I activate it but stays on in the colder weather when it should be switching off. Did I wire this correctly? Any thoughts?

Thanks!

 

[kimkats]

I think some pics would be helpful in this case. The old board and the new board side by side to show how you wired it.

 

[Coolpool2008]

Ok so I recently learned the the Iaqualink has a help feature which can show if anything is not working properly and it says my solar sensor is "shorted". I dont think it is but I will check it out later.

 

[PoolGate]

Did you write down all of the settings before switching the board? Everything has to be setup again once you change out the board.