Hi Everyone new to the Forum and will need some guidance on bringing up PH after remocing stains from plaster with Acid. PH level is at 6... Not sure if the Total Alkalinity Powder did anything to raise Ph. Any recommendations on Borax???
Hi There New to the Forum. From Tampa
- Thread starter Rodrigo estrada
- Start date
- Jun 7, 2024
- 414
- Pool Size
- 7300
- Surface
- Vinyl
- Chlorine
- Salt Water Generator
- SWG Type
- Intex Krystal Clear
Welcome to TFP. You’ll need to post full test results using a recommended test kit.
www.troublefreepool.com
Swimming Pool Test Kits Compared
What pool test kit should I buy? Why shouldn't I use test strips? Our recommended test kits will pay for themselves in no time!
www.troublefreepool.com
- May 3, 2014
- 62,707
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Welcome to the forum.
Raise your TA to 70. The pH will rise. Use baking soda. Do it in steps. 20 ppm TA at a time.
Raise your TA to 70. The pH will rise. Use baking soda. Do it in steps. 20 ppm TA at a time.
- Jun 22, 2014
- 52,030
- Pool Size
- 17888
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool RJ-45 Plus
