I instaslled a Circupool RJ45+ about a month or so ago. I am having issues with it making chlorine. It's installed correctly - per the manual, but for some reason it is not making chlorine. My pool is about 11,000 gallons (meaning the R45 should be putting out tons of chlorine for a pool this size). It's set to turn on at 10AM and turn off around 6PM. My pump runs at low speed (1200 RPM) starting at 10AM to 4PM, then runs high speed (2600 RPM) from 4PM to 6PM. When the SWG turns on, the generate light is illuminated meaning it is supposed to be generating chlorine.
I just went out and checked it today after checking the free chlorine in my pool at 12:30, and the display was dim (like it was in sleep mode), but the generate light was not on. Because I was having issues with it doing the same thing a few days ago, it was set to 75%. I just turned it to max today. The cell voltage shows about 16v and the cell current was showing negative 1.7A (I've never been able to get it to show a positive value).
The only easy thing that I can think of is that the flow is too low for the cell to generate any chlorine - but I've never seen the light flashing unless I've turned it on when the pump wasn't running (indicating no flow).
I just went out and checked it today after checking the free chlorine in my pool at 12:30, and the display was dim (like it was in sleep mode), but the generate light was not on. Because I was having issues with it doing the same thing a few days ago, it was set to 75%. I just turned it to max today. The cell voltage shows about 16v and the cell current was showing negative 1.7A (I've never been able to get it to show a positive value).
The only easy thing that I can think of is that the flow is too low for the cell to generate any chlorine - but I've never seen the light flashing unless I've turned it on when the pump wasn't running (indicating no flow).