Hi,
I am not sure what type of spa light I have, but I removed it trying to fix it. Putting it back in the wall has proved difficult. The light is a pentair light, but the cord is too short to remove it from the water and there is no housing to attach the pilot screw. All I have is the plastered wall and a wedge. My assumption was that the wedge would somehow provide pressure against the plaster, but I can't seem to make that happen. Does anyone have advice? One additional detail is that I am pretty sure the lights are LED lights.
On a stupid side note, turns out I didn't need to remove the light anyways as all that was needed was to reset one the power outlet on the same circuit.
Thanks for any help!
I am not sure what type of spa light I have, but I removed it trying to fix it. Putting it back in the wall has proved difficult. The light is a pentair light, but the cord is too short to remove it from the water and there is no housing to attach the pilot screw. All I have is the plastered wall and a wedge. My assumption was that the wedge would somehow provide pressure against the plaster, but I can't seem to make that happen. Does anyone have advice? One additional detail is that I am pretty sure the lights are LED lights.
On a stupid side note, turns out I didn't need to remove the light anyways as all that was needed was to reset one the power outlet on the same circuit.
Thanks for any help!
Last edited: