Help, chlorinator off/ high amps

[Ronnie6821]

I have a pro logic that’s about 7 years old and my salt cell went out late summer. I replaced it with one I bought off Amazon, everything been fine until the other day when I received the message chlorinator off/high amps. I went to diagnostics and voltage is +40.58V 10.08A
3000PPM. Any help on the matter would be appreciated.

 

[JamesW]

It's a damaged circuit board.

Remove the board and look for burn damage.

 

[Ronnie6821]

I’ll look at the board.
Thank you

 

[ajw22]

See below for discussion and pictures about Hayward SWG board damage and repairs.

Hayward Aquarite SWG - Further Reading

www.troublefreepool.com

 

[JamesW]

Note that it's a ProLogic, which is different from the Aquarite.

Check the back of the board for a failed solder joint and touch up the bad solder joint as needed.

 

[Ronnie6821]

Found it, yes it is a bad solder joint. Will fix it and go from there.
I do appreciate all y’all’s help!

 

[mknauss]

We are glad you have found our information helpful. Please, if you can, consider making a donation to TFP.
We are staffed by volunteers and are registered as an IRS 501 (c) (3) charity and donations are what keeps the forum operating without advertisements.

Support TFP!