I have an aqualogic system and I’m getting a high amps/salt salt display after replacing my t-cell 15.
I went in to make sure it was set to the proper cell, I’m good there. I had replaced the board before with a refurbished one i got from i believe salt solutions. Im I’m looking at trying to solder the k-1 on board. If anyone has any other ideas please respond. Thanks all
I went in to make sure it was set to the proper cell, I’m good there. I had replaced the board before with a refurbished one i got from i believe salt solutions. Im I’m looking at trying to solder the k-1 on board. If anyone has any other ideas please respond. Thanks all