Hi All, I have a pentair system with intelliFlo VST and master tem 400. I had to install a nsw subpanel and so needed to wire my pool to a new breaker. Since then the heater act weird it heats very slowly as it continuously turns on and off. Everything else is normal. The pump runs at 3000 RPM/41 GPM the pressure valve on the filter is normal. The heater shows no warning light.
I cannot imagine why changing the breaker could trigger this but it is suspicious because it right happened after changing the electrics.
Also I tried to open the thermal regulator to check it but i cannot open it. I almost broke my screwdriver but it would not open.
Thanks!
I cannot imagine why changing the breaker could trigger this but it is suspicious because it right happened after changing the electrics.
Also I tried to open the thermal regulator to check it but i cannot open it. I almost broke my screwdriver but it would not open.
Thanks!