Hello all,
My Hayward SP2300VSP Max-Flo VS pump is set to start in prime mode. When Priming has finished the pump will then switch to speed V3 (3000 rpm) for a short-time, then switch to speed V1 (1500 rpm) and remain at V1, which I've had it running at continuously for a couple of days to help with cleaning up an algae issue.
However, this morning after I hooked up the vacuum, it stopped moving almost immediately, then I noticed that the pump appears to have switched back into prime mode and is stuck there. The display says "Pr 4.0", which I understand to mean it's in prime mode and will remain there for 4 minutes and 0 seconds, but it just stays there.
The other problem is that none of the buttons are functioning, even though there's been no error code displayed; I can't even "Stop/Resume", so the only way to stop it is to turn the wall mounted timer off, after which when turned on again, the pump still has the same issues.
Any ideas?
I appreciate your feedback!
My Hayward SP2300VSP Max-Flo VS pump is set to start in prime mode. When Priming has finished the pump will then switch to speed V3 (3000 rpm) for a short-time, then switch to speed V1 (1500 rpm) and remain at V1, which I've had it running at continuously for a couple of days to help with cleaning up an algae issue.
However, this morning after I hooked up the vacuum, it stopped moving almost immediately, then I noticed that the pump appears to have switched back into prime mode and is stuck there. The display says "Pr 4.0", which I understand to mean it's in prime mode and will remain there for 4 minutes and 0 seconds, but it just stays there.
The other problem is that none of the buttons are functioning, even though there's been no error code displayed; I can't even "Stop/Resume", so the only way to stop it is to turn the wall mounted timer off, after which when turned on again, the pump still has the same issues.
Any ideas?
I appreciate your feedback!
Last edited: