Fusion Soft Won't Stop Producing

[JamesW]

I did call for warranty claim but they haven't come this past week because the weather is too cold for it be running right now.

No, that's my problem. It just produces the entire time the pump in on(minus the cold weather right now which shows it "offline")

Ok, I do not know what else to check.

Let's see what the service person can find out.

 

[JamesW]

AquaPure Cycle Time
The AquaPure has a 3 hour polarity cycle time (3 hours one polarity, 3 hours reverse polarity).

The production cycle time used for chlorine production (observationally) is 30 minutes.

The percentage setting will control how much the cell runs during the production cycle.[3]

For example, at 50%, the cell will run for 15 minutes and off for 15 minutes. Polarity will change every 3 hours.

Boost – 24 Hour 100% Chlorine Production Cycle.

To Enter Boost Mode Press and Hold “Temperature” Button 10 Seconds

Jandy AquaPure SWG - Further Reading

www.troublefreepool.com

 

[JamesW]

Are you controlling it from the keypad or from a different device?

What controller do you use?

Can you adjust the settings from the controller?

Does the display show "JA"?

If no, can you make it go to Aqualink control?

If you disconnect the communication wires, does that allow control from the keypad?

 

[JamesW]

________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________

https://cdn.fluidrausa.com/-/media/zodiac/global/downloads/jandy/automation/h0572300.pdf

 

[JamesW]

TFP is a registered 501(c)3 non-profit that is maintained by user donations.

All of our content is free of advertisements.

Please consider donating at:

Become a TFP Supporter

Help Support TFP Trouble Free Pool is run by a dedicated group of volunteers that … Read more…

www.troublefreepool.com

 

[bcre3306]

Sorry for a huge delay in responding. So I finally got someone to come out and look at it but at that point the chlorine levels were down to 1 ppm because I literally had it turned off for weeks and was testing weekly. When they came they turned it to 5% and let it run for a day and said it's fine. I have now run it at 5% for two weeks and it's at 1.5 ppm which is fine but as it seemed to stop spiking huge numbers. The tech said there is no way that it could get up to 20-25ppm with the SWG.....I clearly know he's wrong as it was sky rocketing but I guess at this point I'll just keep an eye on it.

Thanks again for all the suggestions.

 

[mknauss]

1.5 ppm FC is not 'fine' under any circumstances.
Review FC/CYA Levels

 

[bcre3306]

1.5 ppm FC is not 'fine' under any circumstances.
Review FC/CYA Levels

Sorry, I think you took me saying 1.5 was fine, what I was stating was the increase was fine