Fixing a leaky manual air bleed on Swimclear filter

djdonte

Well-known member
Mar 25, 2019
690
Houston, TX
Pool Size
11300
Surface
Plaster
Chlorine
Salt Water Generator
SWG Type
CircuPool RJ-30 Plus
This thing leaks every few years. Just a dribble but it adds up. I take it apart to clean the o ring and grooves, relube and put it back together, and never am able to stop the leak. I can slow it down though. The assembly is only 20 bucks but it is a pain because I have to take apart the filter to get to the nut below. I have an o ring assortment and I have never had luck getting it to seal with any of them. Hayward doesnt seem to sell the o rings or the orange piece separate. Has anyone had this problem?
 

Attachments

  • IMG_2152.jpg
    IMG_2152.jpg
    659.1 KB · Views: 12
  • IMG_2153.jpg
    IMG_2153.jpg
    337.4 KB · Views: 10
TFP is a registered 501(c)3 non-profit that is maintained by user donations.

All of our content is free of advertisements.

Please consider donating at:

 
Could anyone take a guess at what material the O rings are made from? The O ring assortment I referenced earlier is from a plumbing supply house so surely not resistant to chlorinated water. The leak actually stopped this time... until I need to bleed air again I'm sure.