I have a Pentair EasyTouch system with a Remote. All of a sudden, my remote stopped connecting with the system. It was working fine the day before. I tried sending the wireless address from the panel and putting the remote to receive the address. However, the remote does not see any address to lock. I've attached a video of the card. Any clues? Could surge be an issue? Here is the Video from the antenna board. Click here for video. Board is receiving power. RF and 485 blinks. Any help would be greatly appreciated. I hate spending another $500 on an antenna board when I don't know what's happening.
EasyTouch remote "no comm" all of a sudden. Antenna board is getting power. Could be surge? Video attached.
- Thread starter GKAL
- Start date
- Jul 21, 2013
- 65,181
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
good news is it's not doing the 6-flash death sequence...
have you tried the steps pool clown listed here:
www.troublefreepool.com
it seems to help sometimes when folks power down the outdoor panel first, wait 30 seconds or so and power it back up before doing the address sequence... what firmware are your indoor/outdoor controllers running?
have you tried the steps pool clown listed here:
Pentair Easy Touch help
My Easy Touch wireless says "NO COMM" - the control board works just fine and the wireless unit comes on but won't connect. I replaced the batteries... The pool is almost 4 years old and the antena has been in the same place the entire time. How would I even attemp to find out what is wrong? I...
www.troublefreepool.com
it seems to help sometimes when folks power down the outdoor panel first, wait 30 seconds or so and power it back up before doing the address sequence... what firmware are your indoor/outdoor controllers running?