Pool was ok Overnight however the power just went out and we’re being told we might not get power again until tomorrow night. I was able to drain the pump filter etc. but I’m concerned about my heat pump. I have a Hayward heat pump and I can’t find how to drain it. The Hayward site says to just disconnect the water inlet but does that mean I have to literally disconnect the pipes going into the pump?? Thanks for any help!!
Drain heat pump. Another Texan here!
- Thread starter Lda897
- Start date
If there is a union on it it should be simple enough. You should have your breaker to your pump & heater off so nothing can be turned if power is restored. I am surprised that heat pump does not have a specific drain but if the instructions say to disconnect the pipe then the union should be undone. You may need to wiggle the unit a little to break the seal in the union.
- Jul 21, 2013
- 52,508
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
