I just purchased a home with a pool and an easytouch panel. I have a superflo vs pump and want to set the speed to change when the solar heat turns on, which is how I ended up here.
How do I know for sure if I have an easytouch 4 or 8? It only has 4 relays installed, however the settings show all 7 aux and nodejs-poolController, which I just setup recently, identifies it as an easytouch 8.
Can I just purchase some additional relays and will they work, or do I need to take out the board and look to see if it has both the resistors (r41 and r42) as mentioned earlier in this thread? Anything else?
Also, the software and bootloader look to be very old compared to other versions shared here. Any concerns there? Software is version 1.050 and the bootloader version 1.010
Thanks
How do I know for sure if I have an easytouch 4 or 8? It only has 4 relays installed, however the settings show all 7 aux and nodejs-poolController, which I just setup recently, identifies it as an easytouch 8.
Can I just purchase some additional relays and will they work, or do I need to take out the board and look to see if it has both the resistors (r41 and r42) as mentioned earlier in this thread? Anything else?
Also, the software and bootloader look to be very old compared to other versions shared here. Any concerns there? Software is version 1.050 and the bootloader version 1.010
Thanks