Hello,
I’m researching building a DIY pool heat exchanger. It will be like the one shown in the link below. The outer sleeve will be (1) 10’ - 1 1/2” copper. The inter pipe (where the hot water will go through from the boiler) will be 10.5’ - 1” in diameter. Supply and return will be 1 1/4”. I’m sure I would need to add more 10’ copper sleeves. But I won’t know how many till I do a test run. The boiler is 165btu. Inground pool is 21k gallons. Pump is a Pentair vs pump.
Do you think it will work to heat a 21k in ground pool.
Thank you,
Joe
I’m researching building a DIY pool heat exchanger. It will be like the one shown in the link below. The outer sleeve will be (1) 10’ - 1 1/2” copper. The inter pipe (where the hot water will go through from the boiler) will be 10.5’ - 1” in diameter. Supply and return will be 1 1/4”. I’m sure I would need to add more 10’ copper sleeves. But I won’t know how many till I do a test run. The boiler is 165btu. Inground pool is 21k gallons. Pump is a Pentair vs pump.
Do you think it will work to heat a 21k in ground pool.
Thank you,
Joe