So I have an IC20, about 3 years old. Last year I had to replace the flow switch and all was fine after that. It's been fine until this week. We had a power outage, and when it powers up now, I get no LEDs in the row showing the percentage selected. Flow turns green, but then that's it. It's connected to an intelliconnect, and in the app I can see the temp and salt level, and it seems to be able to adjust the chlorine level. Chlorine levels in the pool are pretty low, only showing as 1-2 ppm, so I bumped it up with some liquid since we had people coming over this weekend. The LEDs that show the level have always indicated the level in the past, and they do light up in diagnostic mode, which only shows 20% used, they just don't indicate anything other than that. Note that the salt level light quit 2 years ago, but I don't really care since it was still working and I know my salt levels anyway.
Anyone ever see this one before or have any thoughts? I need to check and see what the chlorine levels are coming out of the returns to see if it's working. What level should I see there? Of course if it is dead, they're on back order with no estimated ship date according to my pool guy.
Thanks!
Craig
Anyone ever see this one before or have any thoughts? I need to check and see what the chlorine levels are coming out of the returns to see if it's working. What level should I see there? Of course if it is dead, they're on back order with no estimated ship date according to my pool guy.
Thanks!
Craig
I typically run 24/7 at 60% (Kick the pump down to the lowest I can and still maintain flow for the IC20 for 12 hours at night). Planning on a 40 if/when it needs to be replaced, assuming you can ever buy them again 