Hi folks:
Pool is closing today and I've followed the instructions in the "How To" section.
I did a final test this AM. My results are:
FC=17 (drifting down from SLAMing 2 days ago)
PH = 7.8
CH = 400
TA = 70-75
Borates = 15? (I checked in June and haven't added any)
Salt = 3000
Temp = 65 deg
I was about to add some acid to lower PH down to 7.4-7.6 per the "How To" instructions.
But when I do that it seems by CSI gets very low. Like -0.4 And then if you lower the water temp as I expect over the next few months to say 40-45 degrees I'm at -0.6, which is bad.
Is it better if I keep PH where it is at 7.8? I'd like CSI to be in the proper area before closing.
Pool is closing today and I've followed the instructions in the "How To" section.
I did a final test this AM. My results are:
FC=17 (drifting down from SLAMing 2 days ago)
PH = 7.8
CH = 400
TA = 70-75
Borates = 15? (I checked in June and haven't added any)
Salt = 3000
Temp = 65 deg
I was about to add some acid to lower PH down to 7.4-7.6 per the "How To" instructions.
But when I do that it seems by CSI gets very low. Like -0.4 And then if you lower the water temp as I expect over the next few months to say 40-45 degrees I'm at -0.6, which is bad.
Is it better if I keep PH where it is at 7.8? I'd like CSI to be in the proper area before closing.