Connecting IntelliChem to EasyTouch

[Okie Pool]

I am connecting a new IntelliChem controller to the EasyTouch system I installed just a few months ago. I only plan on using the IntelliChem for acid dispensing.
Beside power, is the only connection between the IntelliChem and EasyTouch an RS-485 cable?
I just purchased a 4 wire, 22 AWG, RS-485 cable. I hope that is all I need for install.
Any advice is much appreciated.

 

[mknauss]

Welcome to the forum!
That's it. I assume you have Screenlogic with your ET. You would then go into Configure Screenlogic and indicate that an Intellichem is present.
I suggest you read ABC's of Pool Water Chemistry.

 

[Okie Pool]

I don't have Screenlogic yet. That is next on my list.

 

[mknauss]

I don't have Screenlogic yet. That is next on my list.

OK -- then you will need to go through the ET system. Check the manual.

 

[Okie Pool]

Thanks. Appreciate the quick feedback!