Hey folks, getting the new pool going in the new house, just connected my new heat pump (Raypak), but for some reason can't get it started via aqualink RS remote. The relay fires off, but the heater won't start. Does start fine manual mode tho, so it's definitely a remote connection issue.
I've done the same before when in the old pool and had no issues.
So I on the heater side, 2 wires are connected to 44 and 46 per the raypak instructions.
On the aqualink side I'm connecting to the top bus, two outmost left terminals, labeled low voltage heater... this is where I don't remember... so should I be connecting it to the electric heater relay socket on the bottom?
I've done the same before when in the old pool and had no issues.
So I on the heater side, 2 wires are connected to 44 and 46 per the raypak instructions.
On the aqualink side I'm connecting to the top bus, two outmost left terminals, labeled low voltage heater... this is where I don't remember... so should I be connecting it to the electric heater relay socket on the bottom?
