Hi everyone,
I just had most of my pool equipment replaced last week. Chose a local company based on good reviews and local recommendations, but wasn't completely happy with install process due to delays, miscommunications, etc. They finally finished on Friday. All looked good, but today was the first time I wanted to use the heater. With operation, heater turns on, goes through light show, green spa or pool light is on, yellow heat light flashes, but after about 2-3 minutes red "service heater" light comes on. Display initially shows 66 degrees (my controller shows 71). I did set the temp on the heater to 104 for spa. The main pump they installed is VS pentair pump (I have another booster pump and water feature pump) and is set to run at 2400 rmp. Company is coming back on Monday to take a look, but I was wondering if anyone has any suggestions? Thanks.
I just had most of my pool equipment replaced last week. Chose a local company based on good reviews and local recommendations, but wasn't completely happy with install process due to delays, miscommunications, etc. They finally finished on Friday. All looked good, but today was the first time I wanted to use the heater. With operation, heater turns on, goes through light show, green spa or pool light is on, yellow heat light flashes, but after about 2-3 minutes red "service heater" light comes on. Display initially shows 66 degrees (my controller shows 71). I did set the temp on the heater to 104 for spa. The main pump they installed is VS pentair pump (I have another booster pump and water feature pump) and is set to run at 2400 rmp. Company is coming back on Monday to take a look, but I was wondering if anyone has any suggestions? Thanks.