So I'm 90% sure my AutoPilot 16084 board has failed, just going to confirm that with AquaCal in the morning but has anyone ever found a reasonable price for these boards? I can't find anything less than $600, and these boards use to be $250-300 not that long ago. I am trying to renovate an old system and used to have the DIG-220 myself so I thought, cool. No sweat. BUT, after replacing the cell, tri-sensor, display control, and housing, I STILL got the dreaded "Purifier off. Check flow" error. Before I spend another dime on this system (which has already been extravagant compared to other products on the market, and compared to the cost of pre-covid parts), I was hoping someone might be able to help point me in the right direction as far as troubleshooting goes. All contactors are OK and seated properly, and I can't see any physical damage to the board so at this point there is nothing else I can think of.
AutoPilot DIG-220 board failure
- Thread starter daggnabbit
- Start date
- Jul 21, 2013
- 65,804
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Welcome to TFP.
The best folks for Autopilot support are…
Give them a call.
The best folks for Autopilot support are…
SaltPoolGuys.com: AutoPilot Pool Pilot Experts
An authorized AutoPilot Pool Pilot & AquaCal dealer featuring replacement cells, parts, complete systems & heat pumps. Offers nationwide shipping.
www.saltpoolguys.com
Give them a call.
Thanks for the info! Yes I just spoke with them and they advised it is probably the 20-pin harness rather than the supply. HOWEVER the power supply likely is bad as well, I can see the capacitors bulging out soooo... ha I guess I'll have pretty much a new system by the time I'm done. Would have been cheaper to buy a new system at this point, but I'm already too committed with all the parts I've bought trying to get this thing working