Power Supply fires up, connects to WiFi and seems good. As soon as I connect the vacuum to the other side, all lights go blank and the WiFi signal is dropped. Disconnecting the cleaner results in the power supply and WiFi firing back on. Any suggestions or possible items to look into appreciated. Thanks!
AquaVac 650 Power Supply
- Thread starter HelpNeeded
- Start date
- May 3, 2014
- 58,402
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Welcome to the forum!
Have not seen that robot discussed on the forum. Let's see if this bump helps out.
I suggest you read ABC's of Pool Water Chemistry.
Have not seen that robot discussed on the forum. Let's see if this bump helps out.
I suggest you read ABC's of Pool Water Chemistry.
Thank you for the bump. Thinking this may need to go into the shop. As soon as the connection is made from vacuum to Power supply, the controller powers down. Appreciate any insight that can be contributed.
This will void any warranty. Disconnect the power supply for the outlet, and open it up. See if there is a fuse connected to the incoming power. Replace it. Fuses can blow in such a way that they can pass small amounts of power, however open when higher current are demanded. They act like resistors.