I just recently joined this forum and I have a question. My Aquatrol panel says my salt level is at 0. a few days ago it was at 2800. When i first turn it to on, the power light is on, generating light comes on. but after a minute or so, the generating light goes off, the check salt light comes on and inspect cell light comes on. none of the lights are flashing. We inspected the cell and it is clean as a whistle, no scaling. the
We added 1 bag of salt yesterday and let the pump run.
diagnostics are below:
0 - salt level
89
30.1
0.00
96p
-0
AL-6
1.47
Everything was working fine until we noticed this yesterday. Maybe you can help me determine if my panel went bad. We have a flow switch also that is installed, but it is working fine, after testing it.
Thanks,
Melanie
30' in-ground pool, fiberglass drop-in
Hayward AquaTrol HP Main PCB Circuit Board for AQ-TROL-HP Generator | GLX-PCB-TROL-HP
Hayward Goldline Flow Switch GLX-FLO-RP[
We added 1 bag of salt yesterday and let the pump run.
diagnostics are below:
0 - salt level
89
30.1
0.00
96p
-0
AL-6
1.47
Everything was working fine until we noticed this yesterday. Maybe you can help me determine if my panel went bad. We have a flow switch also that is installed, but it is working fine, after testing it.
Thanks,
Melanie
30' in-ground pool, fiberglass drop-in
Hayward AquaTrol HP Main PCB Circuit Board for AQ-TROL-HP Generator | GLX-PCB-TROL-HP
Hayward Goldline Flow Switch GLX-FLO-RP[