I have Similar issues I’ve seen here where I can set a number in aqualink but the control panel of the aqua pure always shows 0%.
This is a brand new setup part of my recently completed pool.
My pool builder is useless so there’s no recourse going back to him.
I can enable boost from the aqualink and it works ok and I see the “cell on” status.
However when running more normal mode aqualink always shows 0 and I never see “cell on”.
Oddly enough it may be producing chlorine but I’m only 1 day into that test.
This is a brand new setup part of my recently completed pool.
My pool builder is useless so there’s no recourse going back to him.
I can enable boost from the aqualink and it works ok and I see the “cell on” status.
However when running more normal mode aqualink always shows 0 and I never see “cell on”.
Oddly enough it may be producing chlorine but I’m only 1 day into that test.