Aqualink RS8 erratic pump relay cycling during freeze protection
When freeze protection is active, the main pump erratically cycles on and off. This only occurs when freeze protection is active. I have adjusted multiple times the temperature set point for freezing, but regardless of the set point, when freeze protection is active the pump cycles on and off erratically. I have an Aqualink RS8 controller, and since I have purchased the home 2 years ago, this has been occurring anytime freeze protection is active. A previous post identified a solution: “cycle the main power to the system, then clear the memory, and reprogram devices, time and temperature settings. FINALLY, assign an unused device to freeze protection.”
This has not resolved my erratic pump relay cycling during freeze protection.
Any ideas?
When freeze protection is active, the main pump erratically cycles on and off. This only occurs when freeze protection is active. I have adjusted multiple times the temperature set point for freezing, but regardless of the set point, when freeze protection is active the pump cycles on and off erratically. I have an Aqualink RS8 controller, and since I have purchased the home 2 years ago, this has been occurring anytime freeze protection is active. A previous post identified a solution: “cycle the main power to the system, then clear the memory, and reprogram devices, time and temperature settings. FINALLY, assign an unused device to freeze protection.”
This has not resolved my erratic pump relay cycling during freeze protection.
Any ideas?