Hello All. Has anyone found a suitable replacement antenna for the 2.0 model. If so can anyone explain how to install in layman’s terms Thanks in advance
Aqualink 2.0 Antenna - what to use
- Thread starter msmith33557
- Start date
- Jun 24, 2021
- 15,880
- Pool Size
- 29000
- Surface
- Vinyl
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool RJ-60 Plus
Aqualink 2.0 Antenna Replacement
Need a solution, please! The antenna on my Aqualink 2.0 controller disintegrated under the Florida sun and I need a replacement. Called Aqualink tech support looking for the part---they don't sell it, they said, only complete new units for $700. Then looked on a couple of sites, one of...
www.troublefreepool.com
@jmdaniel
How did you connect the antenna, in the Amazon picture it looked like a female connector on the antenna and the IAquaLink need a male connector antenna. Trying to solve the same issue.
How did you connect the antenna, in the Amazon picture it looked like a female connector on the antenna and the IAquaLink need a male connector antenna. Trying to solve the same issue.
Last edited by a moderator:
- Jul 21, 2013
- 65,062
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Post a picture of the antenna connector you have. Jandy has a few different versions over the years.
- Jul 21, 2013
- 65,062
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Last edited:
- Jul 21, 2013
- 65,062
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Screws into the side where the antenna connects to the case.
Similar threads
