I have the 2" Anthony Val-Pak Push Pull Valve as part of my set up. The two pins (V34-021) have sheared off and I'm looking to replace. Does anyone know the diameter of these or what size punch to use? I have replacement pins on the way but can't figure out what size punch I'll need to get the remains of the old pins out. Was hoping to have them at the same time but can measure the new ones once they show up.
Additionally, I'm having some water leak through the top and need to replace the o-ring in the piston cap (V34-153). I tried using a small screwdriver to pry it out but wasn't able to get it out easily. Any tips or suggestions on how to get the o-ring out since it sits inside the groove with the piston shaft passing through to make the seal?
Additionally, I'm having some water leak through the top and need to replace the o-ring in the piston cap (V34-153). I tried using a small screwdriver to pry it out but wasn't able to get it out easily. Any tips or suggestions on how to get the o-ring out since it sits inside the groove with the piston shaft passing through to make the seal?