Adding granular chorline

jwgillis

0
LifeTime Supporter
Oct 18, 2008
42
Yuma, AZ
Had to drain fiberglass inground Pool and add water. Previously added granular chlorine by filling proper amount in measuring cup and spreading into pool. Any problem with this or necessary to disolve first?
 
If it is cal-hypo, I'd dissolve first.


If it is cal-hypo, know that you are raising CH along with raising FC. High CH can become a problem, even in a FG pool.
 
  • Like
Reactions: Newdude
Ok great. Many by you need to drain for accumulated CH from high CH fill water and tons of evaporation. At least it wasn't that. (y)

But if your fill water isn't run through a softener, you'll want to avoid cal hypo to push that draining as far down the line as possible.
 
For every 10 ppm FC added by Dichlor, it also increases CYA by 9 ppm. Trichlor builds up CYA. The same is true for Dichlor, except it's even worse (i.e. a more rapid increase in CYA for the same FC addition).

You can pre-dissolve the dichlor in a bucket of water from your pool and add it when it is dissolved by slowly pouring it in front of a return, deep end preferred, while the pump is running. Dichlor dissolves really quickly so it shouldn't take you very long.

If you decide to broadcast the dry granules, do it in the deep end and brush until everything is dissolved. Granules can cause surface discoloration from direct contact

Make sure you use a VERY clean bucket with NO residue from other chemicals. Use PPE.
 
  • Like
Reactions: JamesW
Dichlor is typically considered to be soluble.

Follow the directions on the package.

If you broadcast, brush until all granules are dissolved.

I would avoid allowing granules to get on any pool surface as it can potentially stain or bleach.

You can dissolve in a clean bucket before adding to the pool.

Never mix different types of granular chlorine in the same bucket or it can explode.

Routine Usage Directions for Swimming Pools

Broadcast Chlorine Sodium Dichlor evenly over a wide area in the deepest part of the pool with the circulation pump running.
To prevent bleaching or damage to the pool surface, use a pool brush to disperse any granules that may have settled to the bottom of the pool.


Dichlor is typically applied by broadcasting the product directly into the water.

 
^^^^^^ they're both not kidding about mixing various forms of chlorine in a bucket. My buddy blew his up. I forget now if he added shock packets to the old tab bucket, or vice versa, but there must have been a trace of the old stuff that mixed with the new stuff. And boom.

Lucky for him it took 5 mins and he wasn't there to be hit with shrapnel and chemicals
 
  • Wow
Reactions: JamesW

Enjoying this content?

Support TFP with a donation.

Give Support
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.