27'x48" Concord pool ordered through Doheny's. Self install as we don't have pool installers near us in Colorado. We finally got the pool wall up and clamped it in place with posts on the exterior while we worked on sand bottom. Left pool area unattended a couple hours to manage life and out of no where we had some huge wind gusts rip through, collapsing the pool wall. Mostly all was fine, although there is a little bend near the bottom of one area. No hole and not a major bend. We took the wall that were still standing down and rolled the wall up again to wait for next weekend for round 2. We were so exhausted after the ground prep, leveling, pavers, unrolling and proper fitting of the wall. We were deflated with getting this far and having all that work collapse. Anyway, should I be concerned about the little bend / dimple or will it fix itself with proper support once all is installed? Thanks in advance for support.