Hi folks,
So I have two large Jandy water colors led lights in my pool, both were install as part of the build less 2 summers ago.
So, as I opened my pool this week, I go to test the lights and immidialaty upon turning them on, the breaker trips (the lights are on their own GFCI breaker, only shared with the outlet that's on the side of the AqualinkRS box). I reset the breaker, cycle them on again and one of the light will no longer work. The other works fine and cycles through the colors just fine so the relay seems to be ok. The breaker had not trip again, which tells me it's not a continued short, rather was a momentary issue, that possibly killed the light? I can read current in both junction boxes, so the electricity is there, being delivered to both lights.
So, what's my next step here? Do I now pull the light and troubleshoot on the other end? Any suggestions, guidance? I'm still hoping that it's maybe not the light as it would royally suck to have to already spend $$$ on the light that only about 2 years old!!
Talking about that... If this is the light, I'm starting to get extremely disappointed with Jandy products. In two years of ownership, I have already replaced main pump (ceased up after one season), Aqualinkntouch display (would not charge) and iAqualink (replaced with 2.0 as the original one was a total POS that never worked properly). So now if I have to replace/service the light as well I will be very unhappy...
In any case, any advise, suggestions, guidance here? Maybe someone had a similar problem?
Sent from my iPad using Tapatalk
So I have two large Jandy water colors led lights in my pool, both were install as part of the build less 2 summers ago.
So, as I opened my pool this week, I go to test the lights and immidialaty upon turning them on, the breaker trips (the lights are on their own GFCI breaker, only shared with the outlet that's on the side of the AqualinkRS box). I reset the breaker, cycle them on again and one of the light will no longer work. The other works fine and cycles through the colors just fine so the relay seems to be ok. The breaker had not trip again, which tells me it's not a continued short, rather was a momentary issue, that possibly killed the light? I can read current in both junction boxes, so the electricity is there, being delivered to both lights.
So, what's my next step here? Do I now pull the light and troubleshoot on the other end? Any suggestions, guidance? I'm still hoping that it's maybe not the light as it would royally suck to have to already spend $$$ on the light that only about 2 years old!!
Talking about that... If this is the light, I'm starting to get extremely disappointed with Jandy products. In two years of ownership, I have already replaced main pump (ceased up after one season), Aqualinkntouch display (would not charge) and iAqualink (replaced with 2.0 as the original one was a total POS that never worked properly). So now if I have to replace/service the light as well I will be very unhappy...
In any case, any advise, suggestions, guidance here? Maybe someone had a similar problem?
Sent from my iPad using Tapatalk