I am getting ready to start electrical work for my pool. I have one Pentair 1HP Superflo 2 speed pump and one Intex swg unit to power. I think I can pull this off myself, and electricans around here are asking 3K to do do work. But before I start I want to see if you can give me some directions, critiques etc.
My main panel is in the garage, 90 feet away from where my pump is. Panel is 200 A rated. I am planing on installing double pole breaker @ 20A each. I will use THWN 8 AWG wire (I know it is more than needed) but this would give me option to expand later.
About 50 feet is through garage and under my patio roof, rest of the wires will be inground ( 18" deep at least) Wire will be in 1" pvc conduit sch80, all glued together).
Now when I get to equipment pad, I will place a Intermatic T30604R (Pool/Spa Control Panel T106M and T104M), that based on their decription does not require any junction boxes or service panels. Once I get to that I will need help wiring it up, if I cannot figure it out based on their wiring diagrams. Panel will be on the 4X4 treated post, 5' of the ground, about 10' from the pool. I have 12V LED light. I guess I need to place transformer somewhere in the outdoor rated panel.
I am confused as far as requirements for emergency shutoff switch and maintenance disconnect.
Do I need to install these also? Does maintenance disconnect comes after this panel? Is it one like this
SIEMENS LNF222R 60 Amp, 2 Pole, 240-Volt, Non-Fused, Outdoor Rated
Would Intermatic PA600 Pool/Spa Emergency Shut Off Switch work as emergency switch?
My main panel is in the garage, 90 feet away from where my pump is. Panel is 200 A rated. I am planing on installing double pole breaker @ 20A each. I will use THWN 8 AWG wire (I know it is more than needed) but this would give me option to expand later.
About 50 feet is through garage and under my patio roof, rest of the wires will be inground ( 18" deep at least) Wire will be in 1" pvc conduit sch80, all glued together).
Now when I get to equipment pad, I will place a Intermatic T30604R (Pool/Spa Control Panel T106M and T104M), that based on their decription does not require any junction boxes or service panels. Once I get to that I will need help wiring it up, if I cannot figure it out based on their wiring diagrams. Panel will be on the 4X4 treated post, 5' of the ground, about 10' from the pool. I have 12V LED light. I guess I need to place transformer somewhere in the outdoor rated panel.
I am confused as far as requirements for emergency shutoff switch and maintenance disconnect.
Do I need to install these also? Does maintenance disconnect comes after this panel? Is it one like this
SIEMENS LNF222R 60 Amp, 2 Pole, 240-Volt, Non-Fused, Outdoor Rated
Would Intermatic PA600 Pool/Spa Emergency Shut Off Switch work as emergency switch?