I got a new backwash valve because my old one broke and am trying to figure out how to replace it since the straights going to it don't have any play, how can I get a new piece of pipe into the new valve?
So I installed the new backwash valve and I didn't use enough glue because I was scared of it falling on the sliding piston assembly and I have a small leak, what should I do
Photos or a link to the model you have would be of great assistance. Depending on make/model it may allow use different size pipe on the inside and a larger size on the outside of pipe. Say 1.5 inside the valve body fitting and 2.00 on the outside.
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Welcome to TFP! For a wealth of pool care information please check out our free Pool School. If you are in need of specific help then we encourage you to Register and ask us here in the forum!