So I have been following the TFP all summer and my pool has looked and tested great. Then about a week and half ago, my cord to my pump fried and we couldn’t run the pump until it was replaced. I kind of just left it. By the way, all summer even though I run my SWG I still have to add bleach often. The SWG doesnt seem to ever maintain FC levels on its own. Can I SLAM looking at the nonSWG chart? Since I am probably low on salt and CYA? (CYA was at 70 earlier in summer but we had a leak and lost a lot of water). Can I keep my CYA at 30 if I turn off my SWG or should I keep running the SWG and just supplement with bleach as needed?
I tested the water yesterday and the results are
FC 0.2
CC 0.6
TA 100
PH 8
CYA 30 or below
I know I need to SLAM, I have the bleach stocked up. I also know I should tackle the PH first, but any other advice? Can I lower PH, start slamming, and add the CYA stuff later just so I can begin?
I tested the water yesterday and the results are
FC 0.2
CC 0.6
TA 100
PH 8
CYA 30 or below
I know I need to SLAM, I have the bleach stocked up. I also know I should tackle the PH first, but any other advice? Can I lower PH, start slamming, and add the CYA stuff later just so I can begin?