Well... I can turn the filter on and it runs.. but about 2 minutes later the alarm goes off that is has a low flow.
The problem with that is this... When I turn the salt water system on to clean the pool and that alarm goes off.. it turns off the cleaning
mode. So... yes.. the filter pump will work, but the salt water system won't work when the alarm is going off. When I first turned the salt water system on .. the "working" light is on and it's doing the cleaning cycle. When the "low flow" alarm goes off.. then the "working" light goes off and it goes into sleep mode.
So... the filter pump will work, but it's useless to run it because it's not cleaning the pool. The bottom of the pool and the sides of the pool are getting slimy and I'm scared that it's unsafe and nasty to swim in. Is that slimy feeling caused by the salt being in the pool but not being cleaned through the salt water filter system?
We have swapped the tubes, drained it, rinsed it, checked the flow sensor. We are not sure on how to purge the air from the lines and the tank. What setting does the 6 way valve have to be on the get the air out..etc...?
Any help would be appreciated.