I looked at those but if I remember correctly you have to replace the cell every 6-12 months.I think the cell costs a couple hundred bucks.I would verify that as it's been quite awhile since I looked at those.
From what others have posted the install is reasonably easy, but not dramatically easier than installing a regular SWG. You still need to drill holes in a section of pipe and you have to have a long enough clear run of pipe where you can install the unit.
I've been very happy with my AutoPilot unit, especially since I stopped using the Total Control features and dropped back to the DIG-220 model. I have also heard really good things about their Nano unit. Keep in mind that the DIG-220 is more expensive than most, though it makes up for it with some nice extra features.
I couldn't find anything concrete about having to replace the cells yearly.I did find that you can get a 1,2or 3yr warranty depending on which vendor you buy from but I couldn't find out exactly what parts are warranted for the 2 &3yrs exactly.
From what others have posted the install is reasonably easy, but not dramatically easier than installing a regular SWG. You still need to drill holes in a section of pipe and you have to have a long enough clear run of pipe where you can install the unit.
Jason - dumb question, but can you explain what you mean by "regular SWG"? I have one of these in my setup (except mine is hard-wired, so it's not that exact model) - PB's choice and I didn't question it. I'm just curious now how this differs from other SWGs.
btw - HoleInOne - I've only had the pool for one season, but so far have not had any issues with the Jandy.
In both cases (Ei and conventional) the control unit is mounted to a nearby wall. In both cases there are complications if you don't have a sufficiently long section of straight pipe where the call/sensor can be installed.
With a Jandy Ei you drill four holes in the pipe (at a specific spacing) and then clamp the cell and sensor packages onto the pipe. The control unit then plugs into an outlet.
With a "conventional" SWG you cut out a section of pipe and then glue the cell (and depending on brand sensor package) onto the pipe. The control unit is then hardwired to the timer/automation unit/switch/circuit breaker (or other power source depending on situation).
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Welcome to TFP! For a wealth of pool care information please check out our free Pool School. If you are in need of specific help then we encourage you to Register and ask us here in the forum!