- May 21, 2010
- 143
Ok im getting a intex swg system to use on my intex 18x48 easy set pool and Im curious where to start on getting it set up.
Here is where I figured i would start and you all can chime in and tell what you think. Here are my specs.
fc- usually 4-9 depending on time of day
cc- usually .5
ph-7.5
ta-150
cya-50
salt 0 i would assume being its regular water. The pool calculator says to add 146lbs to get it to 3500ppm
Here is how I figured I will start it up.
1. get salt and add it and wait 24hours to disolve and check
2. lower ph to 7.0 and aerate to get my ta down
3. Add stabalizer to get cya to 70
4. once ta is where it needs to be I will adjust ph to 7.5 if it isnt there yet.
My question is can I do all this at one time or do I need to wait for salt to disolve?
When I get salt disoved and where I need it I will set up Swg for output I need. Im trying to reduce downtime, so my next question is can I swim while this is still going on or not. I will as well keep adjusting my Fc daily with bleach untill swg is right.
Let me know what you all think about this.
Here is where I figured i would start and you all can chime in and tell what you think. Here are my specs.
fc- usually 4-9 depending on time of day
cc- usually .5
ph-7.5
ta-150
cya-50
salt 0 i would assume being its regular water. The pool calculator says to add 146lbs to get it to 3500ppm
Here is how I figured I will start it up.
1. get salt and add it and wait 24hours to disolve and check
2. lower ph to 7.0 and aerate to get my ta down
3. Add stabalizer to get cya to 70
4. once ta is where it needs to be I will adjust ph to 7.5 if it isnt there yet.
My question is can I do all this at one time or do I need to wait for salt to disolve?
When I get salt disoved and where I need it I will set up Swg for output I need. Im trying to reduce downtime, so my next question is can I swim while this is still going on or not. I will as well keep adjusting my Fc daily with bleach untill swg is right.
Let me know what you all think about this.