I upgraded to an EasyTouch circuit board from a Comp pool board last week, ran fine for a few days, everything worked no problem, pump, cleaner, heater. HAPPY DAYS! Then I encountered a "surging" problem and the pump wouldn't filter. I spoke with Pentair support (after two full days of trial and error maintenance myself) and they advised the new board was probably bad and to return it.
So, I installed the new board on Thursday. No problem, works fine, again.... Turned on the heater today for the first time, and the pump starts to surge again, and the heater won't start.
So having pretty much dismantled my entire system last week looking for air leaks and blockages, I think I've determined it's a power supply issue...
I'm guessing, really guessing, that I've wired it incorrectly, missed a step, or my equipment needs more power and the board is tripping?
At no point has the GFCI or any of the 3 amp fuses tripped....
As far as the install I just matched the old wires from the comp pool to the appropriate spots on the Easytocuh. I didn't mess with the transformer or anything else.
I have a 2.2hp Century Centurion switchless motor single speed pump, and a Pentair mini-me gas heater, with a separate pump for the cleaner.
And just to clarify, it worked for a few days last week.....
Please, somebody show me the light!!!!
So, I installed the new board on Thursday. No problem, works fine, again.... Turned on the heater today for the first time, and the pump starts to surge again, and the heater won't start.
So having pretty much dismantled my entire system last week looking for air leaks and blockages, I think I've determined it's a power supply issue...
I'm guessing, really guessing, that I've wired it incorrectly, missed a step, or my equipment needs more power and the board is tripping?
At no point has the GFCI or any of the 3 amp fuses tripped....
As far as the install I just matched the old wires from the comp pool to the appropriate spots on the Easytocuh. I didn't mess with the transformer or anything else.
I have a 2.2hp Century Centurion switchless motor single speed pump, and a Pentair mini-me gas heater, with a separate pump for the cleaner.
And just to clarify, it worked for a few days last week.....
Please, somebody show me the light!!!!