When I turn the heater on after a minute or so it shuts off and display says; check Ign control. Should I change the ignition control or could it be something else? Thanks
Jandy Legacy inground pool heater
- Thread starter RD1379
- Start date
It sounds like the flame sensor isn't sensing flame. So it lights and then goes out? Does it attempt to re-light?
Pull the front panel off and look for a small grey box like item. That would be the ignition module. See if it has a red LED on it and if so, when this error comes up, is it blinking in a series of blinks?
Pull the front panel off and look for a small grey box like item. That would be the ignition module. See if it has a red LED on it and if so, when this error comes up, is it blinking in a series of blinks?
Well I changed the sensor but that didn't work. I looked at the ignition module and it doesn't blink at all. it does try to re-lite it self 3 times before coming up "Check Ing control". My next option seems to be to change the ignition control. Am I correct or am I just wasting my time and money?
