shaft seal

I already replaced it with the “better quality” Seal (Chemical/Salt Resistant, P/N: 071732S) from the Seal Quick Kit (P/N: 356198) together with the rest of the o-rings and gasket, but I am very surprised this already happened, since I bought the pump (P/N: 011056) brand new last September...

While closing my pool last season, my relatively new Superflo VS (2 seasons = 10 months of use) started losing voltage/tripping it's breaker. It happened relatively quickly after running dry for a few minutes. I had never had any electrical problems with my setup before. The problem seemed to go...

Hi everyone, I just replaced the shaft seal of a leaking Pentair Intelliflo 4 160 variable speed pump. When I put it back together, the pump worked better than before (no little bubbles in the pump lid, still a couple large bubbles). However, there was a consistent drip of water under the...

Hello All, After replacing the motor for my WhisperFlo WF-28 pump and all related gaskets and the shaft seal, I noticed a steady stream leaking from the bottom of the seal plate (see attachments). It turned out two small pieces cracked off the seal plate, and it might have happened when I tried...

I have an older Hayward Super Pump. I’m having trouble finding parts with the correct model number. Any suggestions? I need to replace the ceramic shaft seal, housing gasket, and diffuser gasket. Also, any idea how old this pump is? We bought the house with the pool.

Hi. My Pentair Intelliflo XF was leaking at the base where the motor meets the pump a few weeks ago. I replaced the shaft seal, diffuser and main o-rings. After, no leaking, then about a week to 10 days goes by and the leak is back. When replacing the shaft seal, the old one did not look...