remote control

Hi, my inside controller is an fafco rs4, looks just like the aqualink or jandy rs4 inside controller. It worked fine then all of a sudden all the lights were on (red). I shut off the power at the breaker box and turned it back on then it'll go from looking as if there's no power to all red...

Good day I recently purchased a home with a pool. Problem I’m having is that i didn’t notice the remote to the system was missing. I have Jandy Rs system and I need the remote to kick the pump into the second cycle. It has an IAquaLink 2.0 system and I need advice into which is the replacement...

If you're using njsPC to monitor and control your Pentair EasyTouch, IntelliTouch or IntelliCenter and wanted a wireless remote like the QuickTouch II for under $50 then look no further. There are several generic RF outlets and switches that use the 433MHz frequency for remote control and are...

Hi, I have my AQL2-BASE-RF connected to my ProLogic, and my AQL2-POD reads full bars but reads base station is not responding. I also do not have the option to "teach wireless" for the remote on my ProLogic settings menu. Any ideas on steps to try and how to get my remote connected would be...

Greetings; So, I'm in need of a second pool pump for my juacuzzi. I currently have a Pentair Intelliflo VSF, connected to their ScreenLogic or whatever it is called. It can control only one pump. Ran across this new Black and Decker 3HP pump, which is significantly cheaper that another VSF...

It's 2021 and everything in my backyard I can control from my phone except the Pool Pilot DIG-220. My Jandy panel has later software which no longer works with 3rd party SWGs (thanks Jandy). Chlorinator Translator doesn't work with the Pool Pilot either. What other options exist besides...

Made my own spa side remote for EasyTouch system from simple buttons kit I got on Amazon under $20, works great. I want to add an LED light that will light up when SPA is on. Does anyone know if the orange wire on the Spa Side connection on the EasyTouch sends 12v? 5v? Just want to know what LED...

Hello - I have the Intelliflo VSF with the control panel (which is remote), it is great to set the pump schedule, but I want to connect my MasterTemp heater to run (have power) only when the pump runs. I have an intelliChlor which came with a communication cable that I do not use because it is...