prologic

I had to replace the GLX-PCB-PRO board in my Prologic PL-P-4 system due to the SWG circuit. The original board was configured with v4.30 software (090007-430-01) and the display software is v3.12. The replacement GLX-PCB-PRO board I got is configured with v4.47 software (090007-447-01). After...

I have a Hayward Prologic PL-P-4, GVA24 Hayward actuator on a 3 way Jandy valve. I have plugged in the Solar sensor to the Prologic, i plugged the GVA into Valve-3. I can manually activate the valve using the iPhone aquaconnect app. I went into the setting and changed the Solar setting to...

Hi, I have my AQL2-BASE-RF connected to my ProLogic, and my AQL2-POD reads full bars but reads base station is not responding. I also do not have the option to "teach wireless" for the remote on my ProLogic settings menu. Any ideas on steps to try and how to get my remote connected would be...

Hello, I have my Pentair MasterTemp 400 connected to my Hayward Prologic board via the 2 wire method (18AWG per spec) Fireman Switch to the Heater1 relay on the Prologic I have enabled heater1 in the configuration menu on the ProLogic. I press heater1 and no light illuminates and it says Gas...

I've tried searching through the forums and have found many helpful answers and advice. I have a Hayward PL-PS-8-X288 SmartControl panel and I am trying to automate my spa spillover to run 1 or 2 times a day to cycle chlorinated water from pool to spa. I figured out that I need to use an Aux...

Former owner seemed to rig this to work and it got hit by a excavator which cut a cord, the other actuator then shorted and almost melted the connectors together before blowing the fuse. Managed to get that out and replaced both actuators and the fuse. I can get them to spin working the switch...

My Prologic has started to periodically turn off, but the main display reads "Communication Error". The transformer was running really hot, so I tested the Ohms and it was slightly out of spec 2.9 and 3.3. As result I replaced the transformer. The problem is persisting even with the new...