pentair easytouch

To preface this, we had several short power outages from hurricane Helene and I don’t know if the issue started at that point or a couple days later. About a week and a half ago I noticed my hot tub wasn’t overflowing into the pool. Initially I thought my pool person hadn’t sealed the pump...

I have a pool w/ spa and a single-pump (variable flow) system w/ a heater. There is a single light in the pool and a single light in the spa. I have a Pentair EasyTouch 4-function/relay control center (ET4) w/ the large (40k?) salt-water chlorinator, the ScreenLogic add-on (not sure if it is...

Just installed a Pentair Intelliph system with my Easytouch and IC40 SWG. Pool automation is working fine but when I powered up the Intelliph system for the first time, it said no dispensing due to spa mode. I switched the system to spa and it started dispensing so somehow intelliph sees my...

Another success story :) Thanks to @Telemachus for your detailed procedure for upgrading the ET firmware. Also, thank you to @ogdento ,@jerryt and all other contributors. I have an EasyTouch Lite PSL system, which had a v1.0 firmware, before the firmwares were combined. I snipped the main...

Hello, I have a Pentair EasyTouch connected to a Intelliflo 2 VST. It has been installed and functioning normally for about 5 years. The pump is being called for by the EasyTouch system, but is not starting. In the iOS app, I have a system alert: Pump 1: Communication Lost I believe we...

I am a first time pool owner and have a question about the wiring and programming of my Pentair VSF filter pump with an EasyTouch system. I think my pool builder made a mistake and wired my VSF filter to the load side. This meant the pump wasn't getting power unless the filter relay was...

My apologies up front, I'm not exactly a pool pro. I recently had a Pentair 120 H/C heat pump installed. I have a Pentair EasyTouch control panel with a schedule set to run the pump from 8am - 5pm. On the EasyTouch under Settings > Heat, I have the Set Temp set to 86 and the Heater enabled...

I have a Pentair Easytouch system, The Spa light and pool lights are IntelliBright 5G. In the App on my atch, IOS Phone, and PC the lights will come on manually when I turn them on from any location. I have both lights on individual cicuits so I can control each seperately. My problem is, only...

Hello All. I have no idea what happened or why they stopped working initially, however i am slowly making headway. I am using an Easy Touch 8 by Pentair. I have two valves installed. One controls the waterfall and one the laminar fountains. The waterfall works correctly, however having issues...

Hello! My pool pump stopped working around 5pm last night and won't respond to the app to turn pool mode on. I tried to manually do it as well with no luck. Reset, turned it on and off at the breakers, nothing. I have an error that says pool err and self diagnostics says error 4. Any one have...

Hey all, does anyone have experience going from an ic40 to ic60? The plumbing connections and power center wire are the same, if I just plug and play will the Easy Touch control center recognize the difference?

Hello Everybody! I am new to the forum and hoping I can get a little help. I just completed a backyard remodel and added a Pentair EasyTouch Automation system with Screenlogic2, Intellichlor IC40 SWG and an additional pump (Whisperflo 1 1/2 hp) for some water features. My current pump is a 2015...