Search results

Intellchem hooked up to the Pentair Acid Pump and an IC40 SWG. All settings look good (Relay 2/ICHLOR) When intellchem says it's dosing, nothing happens at the Stenner pump, no movement, noise, nothing. Tried switching to a different pump (I had a chlorine pump that I won't be using) same...

Does anyone know how the RJ12 connector is wired to the EasyTouch board or even why the J2D exists? I figured if I could just plug my current cable into their and then cut the wires on the opposite end for my control panel I’d have more room on the J20 com port to add equipment.

Per the Mastertemp Installation instruction: ”The filter pump should run continuously when the heater is on, and for at least 5 minutes after the heater turns off. Any switches in the pump circuit (including circuit breakers) that can disconnect the pump must also disconnect the heater.” I...

Is there any reason why the pool filter is alwasy situated in the middle. my current plumbing looks like this: But the access is always a pain for filter cleaning. I'm thinking of replumbing it so it looks like this: Note the pump on the right is my water fall pump. Any issues with...

So I’m curious, would there be any advantage to putting my Superflo Motor/Drive in my Whisperflo Pump? Only reason I was considering it was so that I should t have to re-plumb it.

I am about to install the Pentair 521107 Easytouch upgrade for my current Compool LX3800 system. I was wondering if any of the experts or those experienced with this upgrade have come into this. Sigle Body System: First of all, when I reviewed the installation instructions, the first thing I...

Hi everyone. I currently have a Compool CP3800 controller. My single speed motor burned out and I thought I would take advantage and upgrade the motor to a VSP. Upgrading is the easy part. The hard part for me is how I can get the motor wired such that I can actually use the pump given my...