Search results

Jim, New transformer in and system is working. Thanks again for all the help!

Like I noted. I'll let you know when the new one arrives. Appreciate all the help.

Jerry, thanks for the reply. See my updates above. But I did want to answer your mystery question. Attached is a better pic. This EMI filter is connected to the transformer for the Intelleclor control panel.

Reconnected the transformer. Verified power coming into the transformer where black power lead connects. Re-verified that still no voltage coming out of the pin connector. Tested each pair of colored wires, alternated leads from multimeter from same colored wires to make sure I wasn't missing...

Understand and did check for voltage for each of the wires as shown in pics. This was done while the power was on. Got no reading of power from the transformer.

Thanks! Lived here all my life! 7 months out of the years it's great, 5 months are like the meme!

Jim, Pulled the transformer so I could get to it. Will hook it back up to test it. Where do I test for power coming in. I know the 120v is coming from the breaker. Do I have to pull the tape off the transformer? Also, conductivity is good on all three circuit breakers connected to the...

Jim, I get no reading while checking between the two pins on the connector. REd/red, orange/orange and blue/blue. I get 240 on aux2.

Thanks and yes so I could check for voltage coming out of the transformer. Can't get any reading out of the connector.

Jim, Should have included this pic to start with. You are correct on the 240V to each pump. The gound fault has been working, I had checked this as my sprinkler system timer is plugged into it. It is on a sperate feed than the controls.

I saw your post from last year about the transformer and that's why I asked you about this situation. See the attached pics. The control board transformer is wired in the 115V configuration like on the left of the schematic pic. Both sides of the panel buss read 120V. So yes on the pumps. The...

Jim, Thanks for the response. Nothing lights up. None of the buttons on the panel work. My IC40 lights do not come on either. I have a remote that works but it does not connect. Unit is wired for 120v and have 120v out of all breakers. I cant get a reading on my voltmeter from the...

Post moved from old thread -- here. Jim, Just joined the forum. I have an Easytouch 4. local utilty changed out my meter. Had all my electronics off except for my pool. Now my ET4 screen is blank. Have been trouble shooting. All breakers are good, have power to the transformer(520653) as...

Hello from Phoenix.