Search results

Update: I ended up installing a new pump. I tried 357527Z and the part listed on Pentair Replacement part list, 356878Z. Neither one fit appropriately. Since then a manager at Pentair told me to replace the drive with 358289 or 356879Z because he can’t find a replacement keypad assembly...

Thanks much.

Unfortunately, I can’t wait. Thanks for the idea though.

Thank you!! I’ve spent hours on this.

I see where the IntelliFlo VS - 011018 - Discontinued. I don’t see a replacement listed. I need a control panel. What would work? Thanks much. Tenna

Good info!

Tried that. Worked for a bit then all lights went out and buttons don’t work. Ugh

Yes, it is a 011018. He took the keypad component only off. He’s running to Lowes to get the torx to remove the screws from the entire top.

Husband took it apart and dried everything out. Turned it on and it worked for about 30 minutes. The pump continues to run, however, there are no lights and the display is dark. The buttons do not work. The water must have damaged the keypad control and maybe the main circuit. Ugh

Yes. Would that be cause to replace the unit?

UPDATE: The pump ran until 9:00 a.m. this morning (24 hrs after it went into Quick Clean mode) then shut itself off. Display has no lights and buttons do not work. Repair guy came buy and said he’d “start” by replacing the control panel. The pump is probably 15 years old. I’m inclined to...

Thanks much!

Glad I asked. Otherwise I would have poured a gallon of reagent in. Ugh. Thank you!

I’ve read Taylor technologies Cyanuric Acid can be used for stabilizer. Does anyone know if it can? Thanks much! Tenna

Thanks much!!

Had a new liner installed, again. Fourth in 6 years but who’s counting. I use the app to find what chemicals to use in what amounts. I can’t remember if I focus solely on slamming with chlorine or do I adjust for CYA and alkalinity as well? Screenshot of test and slam amount attached...

Also, I have sand filter cleaner. Should I wait to use it?

Early in March I turned the solar on so my granddaughter could swim over the weekend. I forgot to remove the solar cover and turn the solar system off before leaving for 10+ days. Upon returning we had storms and high winds for 2 days. The pool was covered with algae. I thought it was just...

Thanks for all your help. Turns out there was a crack in the piece of equipment the MPV is attached to.

Nothing is going on with the solar as far as I know. Pictures of everything is below.

It goes to zero when off. This is when it’s running at 2600 psi.