Search results

There looks to be something wrong with the fenwal but i can’t find whats wrong with it aside from the bottom being black

I have a Zodiac Legacy LRZ LRZ250EN. I tried turning it on and it makes the right clicking noises and smells like gas but isn't igniting. I took the cover off and noticed that the ignitor wasn't glowing. I took out the 3 screws holding in the hot surface ignitor and the ignitor ceramic parts...

Ok I took the entire thing apart and found the o-ring around the valve turning piece had dirt all over it. Rinsed it off and put it back together and no longer leaks

Here's another picture with the actuator removed. It's leaking from the valve handle area

Can someone please tell me what's the name of this part and also how to fix it from leaking? It's leaking from the part on top that turns clockwise/counterclockwise

I wish I had just used a Jandy drain plug on this

I tried using Loctite epoxy on the outside of the crack but that didn't work at all. Next I tried putting a big blob of JB WaterWeld on the outside of the crack. On the inside of the crack I put a silicone plumbing sealant/caulk. Tested it today and it's no longer leaking

I have the Zodiac legacy LRZ250EN heater. Today I was trying to replace the brass piece that fits into the temperature rise port. I overtightened it and the port cracked. The part to replace this is R0454201 but it's out of stock and backordered with everyone who sells it. Any idea how I can fix...

Won't water come squirting out the place where the thermometer is going in since it's not a tight fitting?

The parts manual says that this port is for the temperature rise test and to use zodiac part R0336000. I bought the part but don't understand where the thermometer is supposed to go. The thermometer doesn't fit tightly with the brass parts. It looks like a cooking thermometer

I have a Jandy LRZ heater with a broken and leaking part on the left side. It's a gauge of some sort. The label right next to it says this is where temperature rise measurements are taken, but the gauge itself isn't shown on the parts diagram and I can't find any Jandy/Zodiac part that looks...

Still trying to figure out how to fix this. I had an irrigation company take a look at it because I figured fixing it would be very similar to working with any other outdoor water pipe but they said the adapters they have won't necessarily fit that kind of pipe and they also don't know what kind...

The pool came with the house. Pool was built in 2014 and I bought the house in 2016. I'm pretty sure that was done by the pool builder due to the way the line goes into the concrete

Just wondering is this type of sloppy worksmanship common or did I get a house with an especially bad pool builder

So should I cut just the part that's leaking or try to replace more of it since it's disintegrating? And if I want to replace a lot of it, how do you deal with the part that's in the concrete

My pool has a water leveler float valve that's supplied by a 1" diameter white hose that attaches to the outdoor hydrant and goes down into the cement and to the pool. The hose has been disintegrating and recently broke. Does anyone know what kind of hose that is and how to repair/replace it -...

I have the Jandy epump with the Aqualink RS controller. When I switch it from pool mode to spa mode, it goes instantly. However when I try to either switch from spa mode to pool mode, or turn the filter pump off while in spa mode, the controller starts flashing ***'s and says the pump will turn...

What stops water from getting into the thing when you take it out?

I have not had the pool panel checked by an electrician. I had a pool maintenance/service company come to look at the light and they just want to replace it. They did not take the light apart to see what's wrong with it. I haven't taken it apart myself since I don't think I'm qualified to work...