Search results

I need a short tool to get the that screw holding in the pump cover, as there is only 6 inches between that and my wall.

Additional photos. A run to Home Depot might be in order

I need a short screwdriver to get the back plate off to get at the wires. Thanks for the help. I think this is beyond me. Going to call a pool repair guy Here are other pics

I don't have a clamp meter like that. However, I will the back panel apart and will get photos of the rest of the stuff.

I put in a new capacitor and it did not help

I've got a 6 year old Pentair WP-28. It typically turns on around 9 and shuts off around 6. Today, around 1, I noticed the pump wasn't on. The case was hot to the touch. I turned everything off and checked that the impeller was free, and it was. The basket was clear of debris. I then...

Plaster is 6 years old And absolutely sure as I saw them toss it in and didn't think it wouldn't dissolve, though it was on the steps I did check all my chem levels. pH was a bit high, 7.9, TA was low at 40, everything else was within normal range. I've been having a hard time keeping TA where...

Also, during the initial build you could see areas that were darker, ie the gunite was showing through. I felt this was a problem but my builder assured me it was normal. For the record, white plaster should be white and opaque, and gunite should not be seen through a thin layer, right?

Someone threw some cal hypo into the pool (gunite/white plaster/chlorine 29k gallons) and it ate away some plaster bad is this? I wasn’t planning on replastetring until next year. Does this change my timeline I am generally on top of my pool chemistries.

I wanted to follow up with this. I removed my 280 and pulled it all apart to inspect it. The bearings on 2 wheels were bad. Replaced the bearings and it ran well again.

I've got a 4 year old Polaris 280 It's driveshaft seems to jam after the back up valve cycles If I manually turn the wheels and unjam them it will work for a few minutes then the wheels will stop moving and jam again after the valve cycles. Sometimes j cam get through a few cycles of the back up...