Search results

Hello. What is supposed to be connected to JP2 and JP4 in an Intellicenter IntelliChlor SCG circuit board?

I have a suction side 3 way valve where I just replaced the the gaskets and valve door because I was having an air problem. When in pool mode I have no air in the pump view window. When I switch to spa mode I am not able to fill up the the filter and I loose suction, eventually causing the...

Hi all. The other day I was going outside to brush the pool and when I got to the spa one of the jet nozzles was laying in the bottom of the spa! See picture of nozzle. How do I put it back in? There does not seem to be any threads to screw it in, or any clips per se to clip it in there...

Hi all, So I have a Sta-rite Max-e-therm 200 natural gas heater, connected to Pentair Intellicenter, will not turn on using the Intellicenter. Not sure where to start with troubleshooting to see where the fault is. I have no display on the Sta-rite when I select "Spa (heater enabled)" on the...

I have a built-in pool and spa. Just within the past week, when I reconfigure valves (supply and drain) from pool to spa mode, once the drain valve is getting set, the water supply slows significantly eventually causing loss of suction and then eventually the pump shuts down due to lack of...

Hello, I am considering self-installing pool automation (have experience with electrical and electronics installations) but am not sure which Pentair system I need to get. I ahve the following: Inground Pool and spa w/spillover) Pump - getting Pentair Intellipro VSF installed (in 2-4 weeks)...

Hi, I have a StaRite SR200 and the Service Heater led is on, as well as an led (on the control board) that I can't find a description for. It is located next to the Max Temperature Set button. Can someone please tell me what that led is (it is the only one on)? Thanks so much in advance!

HI all, I have a Sta-rite 200 and need to replace the manifold bypass valve which requires removing the manifold and reinstalling. My question is will I need to replace the coil/tube sheet o-rings and manifold o-ring as well? Thanks so much in advance!

Hi, first time poster and pool owner. I was going to backwash my DE filter and switched the multiport selector while the pump was running. I didn't realize not to do that (to only change positions when the pump was off). Now water only comes out of the backwash hose no matter what position I...