Search results

Hey guys I havve a low hrs Calimar VSP pool pump that is not turning on. It has no errors and has power and it looks fine it’s just not starting up. No noise no clicks nothing when I try manual mode or wuick clean. I believe this is the common controler to Black and Decker and various other...

Hi all, It’s time for a new salt system. I’ve tried to do some research and there is an overload of info out there. Hoping to get some current recommendations for my needs. Here is the information on my pool. Location Phoenix Size 17K gal Currently running a 1.5 hp VSP 2” system Thanks let me...

So I don’t expect anyone necessarily to have any experience on the Circupool RJ Series Original Salt Generator but my question could be more general about salt cells and the control equipment. My cell has 3 wires to the salt cell only. No flow meter. Does anyone know how the salt generator...

Hey guys I installed my new vs pump (Calimar 1.5hp) into my old set up. Because it does its own control and scheduling I left my mechanical intermatic timer “on” full time. I forgot that the chlorinator runs off that time. What is a simple and low cost way to control the salt chlorinator and run...

Replaced my single speed Whisperflow 1.5hp with a 1.5HP Calimar VS pump. Wanted a 3hp version but due to funding and availability I thought that the swap might be good enough. Looking at the specifications I think what i am seeing makes sense but want more information about general pool pump...

Going to refill my pool and add salt. What salt do you recommend and how should I add it while/after filling?

So I completed my system rebuild and I would like to get the pool as clean as I can. I had several quotes for Acid washing $550 and was wondering what I could do instead. What are your thoughts about cleaning methods for a plaster pool. Here’s what it looks like currently. Its dirty from sitting...

So I am awaiting a Pentair Bulkhead Connector on the inlet to the cartridge filter. I haven’t glued anything in yet. Looking for any feedback on my plumbing and system design. Thanks, Nochain

Hi so I have a Pentair Clean and Clear cartridge filter that has a 1-1/2” drain plug at the bottom. I would like to not discharge all that saltwater in the area of the filter. Ideally I would like to convert the 1-1/2 inch plug into a drain line. I am therefore looking for an 1-1/2 inch O-ring...

Living in AZ the water has a lot of calcium and mineral deposits. Its very hard water here. The issue is concentration over time as the water evaporates the deposits concentrate and its a a real battle. I would like to filter out those hard deposits in a way that's both economical AND fast so I...

Trying to determine what HP I need and if a 1.5HP will be more efficient than a 3HP. My Pool specs 18K Gal 2 floor drains 1 side vac port 1 skimmer 1 water feature running off a 2in pipe (rock fall) 1 smaller sprinkler running off a 1-inch line Currently have a single speed 1.5HP pump...

What are your impressions of the Calimar VS pumps? Do we have much information on their long-term reliability as compared to other pumps?

Whats a good way to clean light Algae on my plaster pool?

Hi all thanks for taking a moment to look at my thread. I don’t have any documentation on my pool and this is my first pool and would like to understand better how it works I have a specific question. I have two inlet pipes going into the pump. I am not sure how these are plumbed and maybe you...

Hi I need to move my pump in order to replace my pad. However the union to the main intake looks to be glued to the T valve (not sure correct name). What’s the best way to do this?